5756
3. Turn the crown to set the time.
• Turn to the right to increase the time and turn to the left decrease the time.
• Turn the crown continuously to move quickly.
To stop, turn the crown to the left or right.
4. After completing the settings, return the crown to the normal position.
• Digital display 2 changes to RES (reset).
WW
16. Using the Timer (TMR)
• The timer can be set from 1 minute up to 99 minutes, in 1-minute units. After the end
of measurement, the time-up tone sounds for about 5 seconds and the watch returns to
the timer initial setting status. (Auto return function)
• Press the lower right button (A) during measurement to return to the initial set time and
start measurement again. (Flyback function)
• Radio waves cannot be received during timer measurement.
<Setting the timer>
1. Pull the crown out to position 1 and turn to
align the mode hand with TMR (timer
mode).
2. Pull the crown out to position 2 to enter the
timer setting status.
• SET is displayed in digital display 2 and
the minute display in digital display 1
flashes.
[Digital display 2]
Minute display flashes
[Digital display 1]
Settings
complete
To Next Page
Loading...
Need help?
General
