To Next Page

To Previous Page

6160

• While the chronograph is being operated, the display of digital display 2 changes as

follows.

* If there are no button (A) or (B) operations for 10 seconds, the watch returns to the

measurement status.

• The measurement continues even if the watch is switched to a different mode during

measurement.

(Reset)

Button (A)

Button (B)

(A)

(B)

(A)

(During measurement)

(Split display)(Measurement stopped)

17. Using the Chronograph (CHR)

• The chronograph can display times up to 23 hours 59 minutes and 59.99 seconds.

• After it exceeds 24 hours, the measurement stops and the chronograph returns automatically

to the reset status.

• Radio waves cannot be received during chronograph

measurement.

1. Pull the crown out to position 1 and turn to align the

mode hand with CHR (chronograph mode).

2. Return the crown to the normal position.

3. A confirmation tone will sound each time you press the

upper right button (B) to start and stop the measurement.

4. Press the lower right button (A) during measurement to display a

split time for 10 seconds. After the 10 seconds, the watch returns

to the measurement status. (Auto return function)

• The measurement mark is displayed during measurement and

during the split display.

• The SPL display flashes during the split time display.

5. Press the lower right button (A) while the chronograph is stopped

to return to the chronograph reset status.

Measurement mark

Mode

switching

position

Button (A)

Button (B)

Citizen PROMASTER NAVIHAWK User Manual

Questions and Answers: