5958
4. When the time is up, END is displayed in digital display 2 and the time-up tone sounds for 5
seconds.
• To stop the time-up tone, press button (A) or (B).
• RES is displayed on digital display 2 and the timer returns to the initial set time.
* The measurement continues even if the watch is switched to a different mode during
measurement.
* The time-up tone does not sound unless the crown is in the normal position.
<Using the timer>
1. A confirmation tone will sound each time you press the upper right button (B) to start and
stop the measurement.
• RUN (run) is displayed in digital display 2 during measurement, and STP (stop) is
displayed when the timer is stopped. The measurement mark comes on during
measurement.
2. Press the lower right button (A) during measurement to return to the initial set time and start
measurement again.(Flyback function)
3. Press the lower right button (A) while the timer is stopped to return to the initial set time.
• Digital display 2 changes to RES.
[Digital display 2]
Measurement
mark
[Digital display 1]
Button (B)Button (B)
To Next Page
Loading...
Need help?
General
