6766
• The correction location changes in the following sequence: Alarm ON/OF c City name c
Alarm: Hours c Alarm: Minutes.
• City name: Turn the crown to select the city.
• Alarm hours/minutes: Turn the crown to the right to move the time forward and to the left
to move the time back.
Turn the crown continuously to move quickly. To stop, turn the crown to the left or right.
5. Press the crown back into its normal position.
<Alarm tone check>
In AL-1 or AL-2 mode, the alarm tone can be
checked by pulling the crown out to position 1
and pressing the lower right button (A).
Select alarm ON or OF (off)
Button (A)
Select the city (turn the crown)
Correct the hour (turn the crown)
Correct the minute
(turn the crown)
Button (B)
(B)
(B)
(B)
<Alarm 1 or 2 correction status>
Button (B)
Position 2
Button (A)
WW
19. Using the World Time Alarm (AL-1 and 2)
• An alarm can be set for the set city time.
• Once a day, the alarm will sound for 15 seconds when it reaches the set time. To stop the
alarm, press button (A) or (B).
• The sound of the alarm is different for alarm 1 and alarm 2, but the setting method is the same.
<Setting the alarm time>
1. Pull the crown out to position 1 and turn to align the mode
hand with AL-1 or AL-2 (alarm mode).
2. Pull the crown out to position 2 to enter the alarm correction
status.
• The set city is called up and ON or OF flashes.
3. Press the lower right button (A) to set alarm ON (set) or OF
(canceled).
• Press the lower right button (A) to switch between ON and
OF.
• The alarm mark comes on when ON is set.
4. Each time the upper right button (B) is pressed, the display
flashes and the correction location changes.
Alarm
mark
Alarm ON/OF
To Next Page
Loading...
Need help?
General
