CITROEN 2002 BERLINGO - Filling and Bleeding the Cooling Circuit

124
ENGINE
ALL TYPES
FILLING AND BLEEDING THE COOLING CIRCUIT
Filling and bleeding
- Fit the cylinder adaptor [2] 4222-T (Picasso) and the filling cylinder [1] 4520-T (all types).
- Use the coolant to ensure protection between - 15°C and - 37°C.
- Slowly fill the system.
NOTE : Keep the cylinder filled up (visible level).
- Close each bleed screw as soon as the coolant flows without air bubbles.
- Start the engine : Engine speed 1500 rpm.
- Maintain this speed until the third cooling cycle (cooling fans cut in and cut out).
- Stop the engine and allow it to cool down.
- Remove the filling cylinder [1] 4520-T (all types) and the cylinder adaptor [2] 4222-T (Picasso).
- Top up the system to the max. mark, with the engine cold.
- Refit the filler cap
E5AP1GNCB1GP00AC