CITROEN 2002 BERLINGO - Adjusting the Delphi Mechanical Injection Pump Controls; Adjusting the Fast Idle; Checking the Thermostatic Sensor; Adjusting the Accelerator Control

157
INJECTION
ADJUSTING THE DELPHI MECHANICAL INJECTION PUMP CONTROLS
Engines : WJZ - WJY
Adjusting the fast idle.
Engine cold.
- Ensure that the lever (2) is up against its stop to the right.
- If not, adjust the tension of the cable (3) using the cable clamp (1).
- Finish tensioning using the sleeve tensioner (4).
Engine hot.
- Check that the cable (3) is in tension.
Checking the thermostatic sensor.
- There should be a minimum 6 mm cable travel between a cold and a hot engine.
Adjusting the accelerator control.
Prior conditions.
- Engine hot (cooling fan is engaged twice).
Checking the accelerator cable tension.
- Fully depress the accelerator pedal.
- Check that the lever (6) is against its stop (5) otherwise, alter the position of the pin.
- If not, adjust the position of the accelerator cable tensioning retaining pin.
- Ensure that in the idle position the lever (6) is against the stop (7).
B1HP0K9C
XSARA