174
CLUTCH
GEARBOX
DRIVESHAFTS
CLUTCH : CHECKS AND ADJUSTMENTS
Pull-action clutch with automatic adjustment (non-adjustable) (
*
)
RFS – RFN – RHY - RHY
Gearbox
Engines
BE4/5
B2BP03DD
Refitting the clutch cable.
- Set the pedal to the high position (contact at A).
- Attach the cable end-piece to the pedal.
- Refit a new clip (3) to the pedal.
- Fit the end-piece (4) to the bulkhead (G6 grease).
- Clip the end-piece (5) to the gearbox.
- Refit the cable to the lever (1).
- Depress the clutch cable several times to set the assembly
in place.
- Check that the end-piece (4) is properly fitted to the bulkhead.
- Check the operation of the automatic adjusting device.
1) - Pull the lever (in direction F), the lever must move
when pulled by hand.
2) - Press the clutch pedal very lightly and repeat the same
operation. The lever should not move back.
(
*
) See pages 176 to 177.).
XSARA - XSARA PICASSO
To Next Page
Loading...
