228
AXLES
SUSPENSION
STEERING
XSARA - All Types
REAR AXLE
- The front mountings are aligned at an angle of 45° in relation to the vehicle’s axis.
- The rear mountings are in parallel with the vehicle’s axis.
NOTE : There are two suppliers for the mountings:
- RBT, identified by a Green or Yellow painted dot on the side of the mounting.
- PAULSTRA, identified by a Black painted dot on the side of the mounting.
It is ABSOLUTELY FORBIDDEN to swap components of different suppliers.
Operating clearance - X = 1 to 1.4 mm.
NOTE : The RH torsion bar can be identified by
1 paint line.
The LH torsion bar can be identified by 2 paint
lines.
B3DP04UDB3DP04TC
To Next Page
Loading...
