69
ENGINE
CHECKING AND SETTING THE VALVE TIMING
Engine : CFA
Fit a new O-ring seal on the guide-tube of the oil level gauge.
Coat the O-ring seal with a thin layer of engine oil.
Refit the guide-tube of the oil level gauge with the screw.
Tightening torque : 1 ± 0,1 m.daN.
Refit the alternator
(see corresponding operation)
.
Position the elastic clip for the coolant pump.
Apply seal paste
(AUTOJOINT OR)
on the surround of the sump.
Refit the engine-gearbox assembly
(see corresponding operation)
.
Refit the driveshafts
(see corresponding operation)
.
Refit the sump.
Refit the auxiliary drive belt
(see corresponding operation)
.
Fill and top up the engine and the gearbox
(see corresponding operation)
.
Fill and bleed the engine cooling circuit
(see corresponding operation)
.
Check all the levels.
Reconnect the battery negative terminal.
IMPERATIVE : Perform the operations that are required following a battery reconnection
(see
corresponding operation).
B1D201ND
B1D201MD
To Next Page
Loading...
