ISOFIX" MOUNTINGS
Your vehicle has been approved in
accordance with the new ISOFIX
regulation s .
The outer rear seats are fi tted with
regulation ISOFIX mountings.
In the rear
This ISOFIX mounting system pro-
vides fast, reliable and safe fi tting
of the child seat in your vehicle.
The ISOFIX child seats are fi tted
with two locks which are secured
easily on the two rings A , following
installation of the guides (supplied
with the seat).
Some also have an upper strap
which is attached to the ring B or C .
To attach this strap in the rear, re-
move the vehicle seat's head re-
straint and stow it. Lift the cover on
the rear shelf (Saloon) or the roof
(Tourer). Then fi x the hook on the
ring B or C and tighten the upper
strap.
The incorrect installation of a child
seat in a vehicle compromises the
child's protection in the event of an
accident.
For information regarding the
ISOFIX child seats which can be
installed in your vehicle, consult
the table of positions for fi tting
ISOFIX child seats.
Saloon
These are three rings for each outer
rear seat:
- two lower rings A , located be-
tween the vehicle seat back and
cushion, indicated by a label,
- an upper ring B , fi xed to the rear
shelf, concealed under a fl ap
with the logo TOP TETHER be-
hind the head restraint.
Tourer
- two lower rings A , located be-
tween the vehicle seat back and
cushion, indicated by a label,
- an upper ring C , fi xed to the
roof on the boot side, concealed
under a fl ap with the logo TOP
TETHER.
To Next Page
Loading...
