IV
74
ACCESS
Reactivation of the interior
volumetric and anti-tilt
monitoring
) Press the unlocking button on the
remote control to deactivate the
exterior perimeter monitoring.
) Press the locking button on the
remote control to activate all the
monitoring functions.
The indicator lamp in the button
again fl ashes once per second.
Triggering of the alarm
This is indicated by sounding of the
siren and fl ashing of the direction in-
dicators for thirty seconds.
The monitoring functions remain
active until the alarm has been trig-
gered eleven times in succession.
When the vehicle is unlocked using
the remote control, rapid fl ashing of
the indicator lamp in the button in-
forms you that the alarm was trig-
gered during your absence. When
the ignition is switched on, this fl ash-
ing stops immediately.
Failure of the remote control
To deactivate the monitoring func-
tions:
) unlock the vehicle using the key
in the driver's door lock,
) open the door; the alarm is trig-
gered,
) switch on the ignition; the alarm
stops; the indicator lamp in the
button goes off.
Locking the vehicle without
activating the alarm
) Lock or deadlock the vehicle us-
ing the key in the driver's door
lock.
Operating fault
When the ignition is switched on,
fi xed illumination of the indicator
lamp in the button indicates a fault
with the system.
Have it checked by a CITROËN
dealer or a qualifi ed workshop.
Automatic activation *
2 minutes after closing the last door
or the boot, the system is activated
automatically.
) To avoid triggering the alarm
when entering the vehicle, fi rst
press the remote control unlock-
ing button.
* Depending on country of sale.
To Next Page
Loading...
