CITROEN C5 User Manual

BLEEDING THE DIESEL FUEL
FILTER
Protective cover
Removing the cover
Bleeding water from the fuel
filter
Bleed regularly (at each oil change).
To bleed the water, slacken the bleed
screw or the water in diesel fuel sen-
sor, located at the base of the fi lter.
Continue until all the water has
fl owed out.
Then tighten the bleed screw or the
water detection sensor.
HDi 115, HDi 160 and V6 HDi 240
engines
) Pull the protective cover upwards
to remove it.
HDi 140 engine
) Remove the protective cover by
fi rst unclipping at 3 , then 1 and 4.
) Unclip at 2 by pulling towards
you, then lift up.
Refi tting
) Firstly clip in at 2 .
) Lower and centre the cover.
) Clip in at 3 and 4 , pushing verti-
cally and gently from the rear.
) Clip in at 1 pushing vertically.
CHECKS
163
CHECKS

CITROEN C5 Specifications

General

Brand	CITROEN
Model	C5
Category	Automobile
Language	English