IX
138
DRIVING
The position of the gear lever the the
driving mode are displayed in dial C
of the instrument panel.
A selection grille alongside the gear
lever also allows you to see the se-
lected position.
Displays in the instrument panel
Moving off
) To start the engine, the gear le-
ver must be in position N .
) Press the brake pedal down fully.
) Operate the starter
N appears in the instrument pan-
el screen.
N fl ashes in the instrument panel,
accompanied by an audible signal
and a message in the multifunction
screen, if the gear lever is not in
position N on starting.
) Select fi rst gear (position M or A )
or reverse (position R ).
) Release the parking brake un-
less it is programmed in auto-
matic mode.
) Release the brake pedal, then
accelerate.
) With your foot on the brake, push
the lever forwards.
Reverse
Only engage reverse with
the vehicle immobilised.
To avoid any jerking, wait a
moment before accelerating.
Neutral
Never select position N with
the vehicle moving.
To Next Page
Loading...
