IX
!
145
DRIVING
Never select positions P or R
if the vehicle is not stationary.
If, while the vehicle is moving, po-
sition N is engaged inadvertently,
allow the engine to idle before en-
gaging position D or M .
Moving off
) To start the engine, the gear le-
ver must be in position P or N .
) Operate the starter.
) When the engine is running,
place the gear lever on R , D or
M as required.
) Check, in the instrument panel,
the position engaged.
) Release the brake pedal and ac-
celerate.
) To avoid a possible difference
between the position of the gear
lever and the actual position of
the gearbox, always exit from
position P with the ignition on
and brake pedal applied.
Otherwise, when the ignition is on or
the engine is running:
) reposition the gear lever in posi-
tion P ,
) put your foot on the brake ped-
al and then select the gear you
want.
Park
This position of the gear le-
ver is used to prevent the
vehicle from moving when
you are stationary.
) To select position P, move the
gear lever back to the highest
position (towards R ), then push
it forwards and then to the left.
) To exit position P , move the gear
lever to the right and then to the
position you want.
) Only engage this position when
the vehicle is completely sta-
tionary. In this position, the front
wheels are locked. Make sure
that the gear lever is correctly
positioned.
Reverse gear
Only engage this position when
the vehicle is stationary. To pre-
vent snatching, do not accelerate
too soon after selection.
Neutral
Never select position N if
the vehicle is moving.
To Next Page
Loading...
