IX
133
DRIVING
SITUATION CONSEQUENCES
4
Display of messages " Parking brake faulty "
and " Anti roll-back fault " and of the follow-
ing warning lamps :
and/or fl ashing
- The automatic functions are deactivated.
- The hill start assist is not available.
To apply the electric parking brake:
) Immobilise the vehicle and switch off the ignition
) Pull the control lever for at least 5 seconds or until maximum
application.
) Switch on the ignition and check that the electric parking brake
warning lamps are on.
- Application may take longer than in normal operation.
- If warning lamp (!) fl ashes or if the warning lamps do not come
on when the ignition is switched on, this method does not work.
Have it checked by a CITROËN dealer or a qualifi ed workshop.
To release the electric parking brake:
) Switch on the ignition.
) Push the control lever and hold it for approximately 3 seconds.
5
Display of message " Parking brake control
faulty – automatic mode activated " and the
following warning lamps:
and/or fl ashing
- Only the functions for automatic application on switching off the
engine and automatic release on acceleration are available.
- Manual application/release of the electric parking brake and dy-
namic emergency braking are unavailable.
6
Display of message " Parking brake faulty "
and of the following warning lamp:
fl ashing
- Application of the parking brake is not guaranteed.
- The parking brake is temporarily unavailable.
It this situation arises:
) Wait approximately 3 minutes.
) After 3 minutes, if the warning lamp is still fl ashing, try to reini-
tialise the parking brake, either by pushing and releasing the
control A while pressing the brake pedal or by means of a long
pull on control lever A .
7
Battery problem - Illumination of the battery warning lamp makes it essential to stop the
vehicle as soon as traffi c allows. Stop and immobilise your vehicle.
- Apply the electric parking brake before switching off the engine.