108
CLUTCH
GEARBOX
TRANSMISSION
AM6 GEARBOX CONTROLS
The gear selector is guided by the shape of the stepped gate and by a retaining spring which
pulls it to the left hand side.
The gear control has 5 positions:
- Position "P": parking (locking and immobilisation of the vehicle).
- Position "R": reverse gear.
- Position "N": neutral.
- Position "D" : drive (for use of the 6 gears in autoadaptive automatic operation).
- Position "M": manual (this position allows the driver to select his gears in one-touch mode by
pulling "M -" or pushing "M +" on the gear selector).
NOTE: Only positions "P" or "N" authorise starting of the engine.
In position "M", the selection is enabled by an electronic sensor located close to the gear
selector:
- The variation of flux necessary to affect the sensor cells is obtained by a magnet on the lever
opposite the cells, provoking the changes of status.
- The information on this is transmitted to the gearbox ECU.
B2CP430D
Engines: ES9A - DT17BTED4
To Next Page
Loading...
