201
HYDRAULICS
DE-PRESSURISING THE HYDRAULIC SUSPENSION CIRCUIT
Tools.
[1] PROXIA station : 4165-T
[2] LEXIA station : 4171-T
De-pressurisation.
NOTE: It is possible to de-pressurise the suspension by individual axle.
Using a diagnostic tool.
Start the engine.
Place the height control in the «LOW» position.
Wait for the vehicle height to reach the position required.
Stop the engine.
Connect the diagnostic tool [1] or [2] to the vehicle's diagnostic socket.
Switch on the ignition.
Carry out a global test.
Go into the menu:
- Suspension.
- De-pressurisation.
Follow the instructions displayed on the screen.
Wait for the vehicle's suspension to sink completely.
NOTE: This operation takes around 3 minutes.
Switch off the ignition.
Disconnect the battery.
Without a diagnostic tool.
IMPERATIVE: Any LDS fluid that is collected must not be re-used.
NOTE: Collect the LDS fluid in order to keep the work area clean.
Respect the environment.
Start the engine.
Place the height control in the «LOW» position.
Stop the engine.
To Next Page
Loading...
