42
ENGINE
SPECIAL FEATURES: CYLINDER HEAD TIGHTENING
Engine: ES9A
B1DP1KHC
Cleaning to be carried out just prior to refitting the cylinder head
WARNING: Clean the contact faces with the approved CITROËN cleaning product.
Do not use abrasives or cutting tools on the contact faces.
The contact faces must not bear any traces of impact or scratching.
Insert a tap in the threads of the holes in the cylinder block receiving the cylinder head bolts.
Brush the threads of the cylinder head bolts.
Oil the threads and under the heads of the bolts, using MOLYKOTE G RAPID PLUS.
Engine Tightening (from 1 to 8) X = MAX. re-usable length
Pre-tightening 2 ± 0,2
ES9A
Slackening yes
149,5 mm
Tightening 1,5 ± 0,1
Angular tightening 225° ± 5°
IMPERATIVE: Take new screws if their length is greater than X mm
.
NOTE: Tightening of the cylinder head after a repair is prohibited.
B1DP1KEC
Front cylinder head
Rear cylinder head
To Next Page
Loading...
