CITROEN C6 2005 - Braking System: General Specifications

165
AXLES
SUSPENSION
STEERING
Tools.
[1] Pipe spanner : FACOM 18.17
[2] Set of 2 hose clamps : 4153-T
[3] Pressure checking assembly :
[3a] Pressure gauge : (-).0710.AZ
[3b] Checking tube: Pressure gauge to tap : (-).0710.B1
[3c] Checking tube: High pressure pipe to tap : (-).0710.B2
[3d] Checking tube: High pressure pump to tap : (-).0710.B3
[3e] 3-way tap : (-).0710.C
[4] Union : (-).0710.E1Z
[5] Union : (-).0710.E2Z
[6] Plug for checking sealing of the steering valve : (-).0410.N
Precautions to be taken.
Work with care to avoid entry of polluting particles.
NOTE: Correct operation of the system requires the LDS fluid and the hydraulic components
to be perfectly clean.
Check:
- The level of the LDS fluid (see procedure: drain-fill-bleed the suspension circuit).
- The condition of the piping and unions.
Using the tools.
Prepare the checking assembly [3], [4] and [5].
Remove the bracket (1).
Clamp the pipe at "a", using tool [2].
Uncouple and move aside the piping (2), using tool [1].
E5AP2PND
B1BP3GPD
CHECKING THE STEERING ASSISTANCE PRESSURE (ES9A ENGINE)
Angl-C6-page121-169-2005 4/02/05 17:31 Page 165