169
AXLES
SUSPENSION
STEERING
Precautions to be taken.
Proceed with care so as to prevent any entry of polluting particles.
IMPERATIVE: Respect the safety and cleanliness requirements.
IMPERATIVE: Fill the LDS fluid reservoir with new fluid: TOTAL LDS.
Bleeding.
Check the level and top up the LDS fluid (see procedure: drain-fill-bleed the suspension circuit).
Apply a pressure of 0.5 bar in the LDS fluid reservoir (using tool FACOM 920).
Start the engine.
Wait for the vehicle height to stabilise.
Move the steering in each direction, from lock to lock.
Stop the engine.
Check the level and top up the LDS fluid (see procedure: drain-fill-bleed the suspension circuit).
BLEEDING THE HYDRAULIC STEERING ASSISTANCE CIRCUIT
To Next Page
Loading...
