CITROEN C6 2005 - Braking System: Tightening Torques

168
AXLES
SUSPENSION
STEERING
Remove:
- The exhaust line (3).
- The tool [6].
Couple the two supply pipes (5) on the distributor valve.
Refit:
- The bracket (7).
- The screw (4), tighten to 0,8 ± 0,1 m.daN.
Retighten the union (6) on the power steering ram; tighten to 1,4 ± 0,35 m.daN.
Refit the exhaust line (3).
Pinch the pipe at "a", using tool [2].
Remove:
- The assembly [3].
- The union [5] on the pipe (2).
- The union [4] on the steering assistance pump.
Couple the pipe (2), using tool [1].
Tighten the pipe (2) to 2 ± 0,2 m.daN.
Refit the bracket (1).
Bleed the hydraulic steering assistance circuit (see corresponding operation).
Top up the level of the LDS fluid (see procedure: drain-fill-bleed the suspension circuit).
B1JP08WD
B3EP185D
CHECKING THE STEERING ASSISTANCE PRESSURE (ES9A ENGINE)
Angl-C6-page121-169-2005 4/02/05 17:31 Page 168