AXLES
SUSPENSION
STEERING
128
CHECKING AND ADJUSTING VEHICLE HEIGHT
Reference heights: REFERENCE = Ignition switched on
Adjusting the heights.
Calculate the following values:
- Front LH : K1M = R1 - H1M.
- Front RH : K2M = R2 - H2M.
- Rear LH : K3M = R3 - H3M.
- Rear RH : K4M = R4 - H4M.
Connect the diagnostic tool [3] or [4] to the vehicle's diagnostic socket.
Switch on the ignition.
Perform a global test.
Go into the menu.
Variable damping.
Adjustment of vehicle reference heights.
Enter the values K1M, K2M, K3M and K4M in the diagnostic tool.
WARNING: The values should consist of 4 figures: Example: K1 = 160 mm - enter the value 0160.
Checking the heights after adjustment.
Check the heights:
- Front LH : K1 = 160 ± 6 mm.
- Front RH : K2 = 160 ± 6 mm.
- Rear LH : K3 = 111 ± 6 mm.
- Rear RH : K4 = 111 ± 6 mm.
To Next Page
Loading...
