79
ENGINE
DRAINING, FILLING AND BLEEDING THE ENGINE COOLING CIRCUIT
Open the plug (3) to drain the second bank of cylinders.
Remove the drain plugs (2) and (3).
Filling and bleeding the circuit.
Prior to any filling, rinse the cooling with fresh water.
WARNING: Check the sealing of the cooling circuit.
Open the bleed screws of the following components:
- Heater matrix outlet.
- Coolant outlet housing.
- Radiator.
Close the drain screw (1) of the radiator.
Refit the plugs (2) and (3) with a new seal ; tighten to 3 ± 0,3 m.daN.
Fit the filling cylinder assembly [1], [3], and [2] on the filler aperture.
Fill the cooling circuit.
NOTE: Keep the filling cylinder full to the maximum.
B1GP08TC
Engine: ES9A
B1GP0BQC
To Next Page
Loading...
