Vessel Crystal Right Soda Ash Dissolved
Size Volume Ammount In Water
1044 1.0 CU,FT 400 Gramms 2 Ltrs
1054 1.5 CU,FT 600 Gramms 3 Ltrs
1252 2.0 CU,FT 800 Gramms 4 Ltrs
1354 2.5 CU,FT 1.0 KG 5 Ltrs
1465 3.5 CU,FT 1.4 KG 7 Ltrs
1665 4.5 CU,FT 1.8 KG 9 Ltrs
1865 6.0 CU,FT 2.4 KG 12 Ltrs
2160 7.0 CU,FT 2.8 KG 14 ltrs
2469 11 CU,FT 4.4 KG 22 Ltrs
3072 19 CU,FT 7.6 KG 38 Ltrs
3672 26 CU,FT 10.4 KG 52 Ltrs
CRYSTAL RIGHT SODA ASH REGENERATION CHART
Mixing the Soda Ash with warm water will dissolve the granuals quicker
Soda Ash Shock Treatment
The Soda Ash is prepared in the same way and to the same strength as the routine procedure, the difference
being during the shock procedure it is drawn direct from the container it is prepared in. The easiest way to do
this is to disconnect the regular brine draw tube from the brine elbow, re-connect a piece of flexible tube to the
elbow the other end of which is put into the Soda Ash solution.
I. The first stage of the shock treatment is to backwash the unit for the standard length of time
II. After the backwash the liquid soda ash is drawn into the bed as per the above guidelines, immediately
all the soda ash solution has been drawn into the valve the original brine line is re attached to the brine
elbow and the brine draw initiated and the standard regeneration cycle allowed to run its course.
III. Important When using the shock method monitor the pH of the rinse water going to drain, if CO2 is
being released from the Crystal-Right the pH of the rinse water will drop, the lower the pH the more gas
is being released from the crystals.
What Concentration and how much Soda Ash
The correct solution strength is made by dissolving 200 grams of Soda Ash in 1 litre of water. Each cubic foot of
Crystal Right will require 2 Litres of Soda Ash solution for regeneration.
To Next Page
Loading...
Need help?
General
