3. Your System.
3.1 Identifying your System.
Your System will have an identification label fixed to the control valve, this will look similar to
the picture shown here.
The information listed can be read as follows:
Stock Number: Manufacturers part number.
Serial No: Serial No.
Id Code: System type identification code (soft, CR100, CR200 Nitrate or
Colour).
Configuration: Vessel size, Valve type & Controller type.
Identify the settings from the chart in the programming section.
The valve is supplied pre programmed!
(excluding settings that need to be done on site)
The settings are listed in case there is a need to re
program the unit.
If you have any concerns or worries following the setting procedure please contact your
supplier who will help you through the set up procedures.
Using the above information to identify your system you can then select the
relevant setting sheet from the following pages.
To Next Page
Loading...
Need help?
General
