N.I.C.E.
53
If the address is not on the map, touch the map
in the direction of the address as if your finger
was doing the traveling.
Continue touching the map until you find the
location.
2. Press the push pin button (F5).
The unit displays the selected location as a list
item.
3. Press the name to confirm the location.
4. Press Set Vehicle Position.
The red pointer moves to this position.
Define your destination
Touch your destination as you did for defining your
current location.
OR
Press the navigation button (F3) and use the menus
to define your destination.
As soon as definition is complete:
• The unit calculates the route and begins route
guidance.
• The red pointer moves along the route in 0.01
mile increments.
• A beep sounds when the unit turns onto a new
street.
After you’ve previewed your journey,
Simulation automatically resets itself
to off.
Note
To Next Page
Loading...
Need help?
General
