Clarion NZ500 - Navigation System Operations

32 NX500/NZ500
English
Owner’s Manual
Navigation System Operations
Introduction to Navigation Software
Navigation software provides turn-by-turn
visual and voice assistance to direct you to
selected destination. The software quickly
calculates step-by-step directions to any
destination available on the included
navigation map. The navigation software uses
Global Positioning System (GPS) satellites, and
a digital roadway map database to calculate
and display travel directions. The system’s GPS
antenna receives signals from a constellation
of 24 satellites orbiting the earth and uses the
strongest of signals, to determine your position
to within meters.
Vehicle Position
The navigation software’s computer considers
vehicle speed and heading changes, together
with longitude and latitude information, to
accurately determine vehicle heading and
position on a digital map. Signals from GPS
satellites are used to determine the vehicle
location. Three (good) or four (best) satellites
must be received to accurately determine
location. The GPS reception status is indicated
by the GPS symbol on the map.
Map and Information Database
The map database used by navigation software
was created using high-resolution aerial and
land based data collection. Car navigation maps
are frequently updated. While the database was
judged to be as accurate as possible at the
time of its release, a map database can never
be 100% accurate. Road information that is
maintained in the map databases, such as turn
restrictions or road names may change over
time.
Main Menu Screen Operations
1. After the navigation system is activated
by touching “NAVI” button on the Main Menu
screen, the warning screen is displayed.
Press the button to accept it.
2. The ”Main Menu” navigation screen is
displayed.
3. Main menu screen has different options:
Home Address - Route to home address.
Go To... - Select a destination for navigation.
Setup - Set pr
eferences for routing and
navigation display.
Office Address - Route to office address.
Trip Computer - Display speed, trip,
odometer reading, clock reading.
4. To operate the navigation system use display
function buttons as described below.
Zoom in the map to show a smaller
area
Zoom out the map to show a larger
area
Return to Map mode
Display map in 2D view
Return to the previous screen
Display menu, jump to main menu
Display map in 3D view
Select current panned position,
after panning map.
Information about current location
on the map, mode items
Select (check) currently highlighted
item
Display spell mode
Page up, page down in
displayed list
Step up or step down on menu list
Voice instractions are activated
Reset button
Cancel button
Delete button (Move cell content to
Trash can)