English
NX500/NZ500 53
English
Owner’s Manual
USB DEVICE
Problem Cause Measure
USB device cannot be
inserted.
The USB device has been
inserted with wrong direction.
Reversing the connection
direction of the USB device,
try it again.
The USB connector is broken. Replace with a new USB
device.
USB device is not recognized. The USB device is damaged. Disconnect the USB device
and reconnect. If the device
is still not recognized, try
replacing with a different USB
device.
Connectors are loose.
No sound heard with the
display “NO FILE” shown.
No MP
3/WMA file is stored in
the USB device.
Store these files properly in the
USB device.
Sound skips or is noisy. MP
3/WMA files are not
encoded properly.
Use MP3/WMA files encoded
properly.
The iPod/iPhone’s video
image is disturbed.
The TV Signal setting of
the iPod/iPhone is not set
correctly.
Set the TV Signal setting
(NTSC/PAL) of the iPod/iPhone
correctly.
9. ERROR DISPLAY
If an error occurs, one of the following displays is displayed.
Take the measures described below to solve the problem.
DVD PLAYER
Display Cause Measure
BAD DISC
A disc is caught inside the CD
deck and is not ejected.
This is a failure of DVD deck’s
mechanism and consult your
store of purchase.
BAD DISC
A disc cannot be played due
to scratches, etc.
Replace with a non-scratched,
non-warped disc.
BAD DISC
A disc is loaded upside- down
inside the DVD deck and does
not play.
Eject the disc then reload it
properly.
PARENTAL VIOLATION
Parental level error Set the correct Parental level.
WRONG REGION
Region code error Eject the disc, and replace
correct region code disc.
If an error display other than the ones described above appears, press the Reset button.
If the problem persists, turn off the power and consult your store of purchase.
* When the Reset button is pressed, frequencies of radio stations, titles, etc. stored in
memory are cleared.
To Next Page
Loading...
