5.1
ch
Surround
Decoder Operations
Setting
and
storing
REQ Properties
1. Press the
[ADJ]
button and touch the
[AUDIO]
key.
2. Touch the [P.EQ] key to show the P.EO
adjusting display.
3.
Touch the key for the desirable type to select
it.
The
PEO
adjustment contents are as
follows:
.SIGNAL
*The factory default setting
is
"P.NOISE".
This function selects
"P.
NOISE"
or
"MUSIC".
.SPEAKER
SELECT
*The factory default setting
is
"FRONT'.
This function selects "FRONT", "CENTER"
or
"SURROUND".
.BAND
*The factory default setting
is
"BAND1".
Select the channel to be compensated
("BAND1", "BAND2", "BAND3").
• FREQUENCY
*The factory default setting
is
"1
kHz".
Select the center frequency that you want to
compensate from the range
of
18
Hz to 20
kHz. (1/3 octave step,
31
points)
• Q
*The factory default setting
is
"1".
Set the sharpness
of
the Q-curve to one
of
the parameters: 1, 3, 5, 7 and 20.
• GAIN
*The factory default setting
is
"0".
Adjust the gain (output level) in the range of
-6
dB
to +6 dB.
(1
dB
step,
13
points)
4. Touch the [RTN]
key,
[ESC]
key,
or
press the
[ADJ]
button.
Selecting the
Dolby
PLII (Dolby Pro
Logic
II)
type
*The factory default setting
is
"OFF".
1.
Press the
[ADJ]
button and touch the
[AUDIO]
key.
Touch the
[Dolby
PLII]
key.
2. Touch the key for the desirable type to select
it.
3. When the setting is finished, touch the [ESC]
key
or
press the [ADJ] button to return to the
previous mode.
Output adjustment
of
subwoofer
volume,
center
volume
and balance/
fader
1. Press the
[ADJ]
button and touch the
[AUDIO]
key.
Touch the [DETAIL]
key.
2.
To
make an adjustment
on:
.Subwoofer
volume
adjustment
2-1. Touch the [SUBWOOFER YOL] key to
adjust to desirable level.
*The factory default setting
is
"0". (Setting
range:
-6
to 3)
•
Center
volume
adjustment
2-1. Touch the [CENTER YOL] key to adjust to
desirable level.
*The factory default
is
"0". (Setting range:
-6
toO)
•
Balance/Fader
adjustment
2-1. Touch the [BAL/FAD]
key.
Touch the
[A]
or
[T]
key to adjust the
balance level.
[A]
key:
emphasized the sound from the
front speakers.
[T]
key:
emphasized the sound from the
rear speakers.
2-2. Touch the [
....
]
or
[
...
] key to adjust the
fader level.
[....]
key:
emphasized the sound from the
left speakers.
[
...
]
key:
emphasized the sound from the
right speakers.
3. Touch the [RTN]
key,
[ESC]
key,
or
press the
[ADJ] button.
VRX755VD 59