17
RED (2) (+)12V input for relays
Remove the two 30 amp fuses prior to connecting these wires and do not replace them until the satel-
lite has been plugged into the control module. These wires are the source of current for all the cir-
cuits the relay satellite will energize. They must be connected to a high current source. Since the fac-
tory supplies (+) 12V to the key switch that is used to operate the motor, it is recommended that these
wires be connected there.
NNOOTTEE::
If the factory supplies two separate (+) 12V feeds to the ignition switch, connect one RED wire of the
satellite to each feed at the switch.
Some vehicles have a low current (10 Vdc) source at the column. For these vehicles it is recom-
mended to connect to the (+) terminal of the battery.
ORANGE (+) accessory output
Connect this wire to the accessory wire in the vehicle that powers the climate control system.
PINK (+) ignition output
Connect this wire to the primary ignition wire in the vehicle.
PINK/WHITE (+) output to second ignition/accessory circuit
Connect this wire to the second ignition or accessory wire in the vehicle (selectable menu feature 2-9).
RED/WHITE 12 V input
If additional current capacity is needed cut this wire, add a fuse adequate for the circuit to be sup-
plied, and connect to an additional 12V source.
4-pin satellite harness wire connection guide
BLUE (-) status output
For use when immobilizer bypass is required.
ORANGE (-) 200mA 2nd accessory output
To drive relay for 2nd or 3rd accessory.
VIOLET (-) 200mA starter output
To drive relay for 2nd starter.
PINK (-) 200mA 3rd ignition output
To drive relay for 2nd or 3rd ignition.
To Next Page
Loading...
Need help?
General
