Clarion VRX8370R - Page 16

oA @) od = FAW Ol
Basic Operations
When
this
unit
is
turned
on,
starting
and
stop-
ping
the
engine
of
a
car
with
its
volume
raised
to
the
maximum
level
may
harm
your
hearings.
Be
careful
about
adjusting
the
volume.
Note:
Use
this
unit
after
starting
the
engine.
ACC
or
engine
ON
position
Turning
on
the
power
and
adjusting
the
volume
1) After turning the car's ignition switch on and
starting the engine, press the POWER button
to turn on the power to the unit.
‘
* This unit starts in the mode it was in when the
power was turned off last.
Press the FUNC button [7] to select the oper-
ation mode.
Each time you press the FUNC button [7], the
operation mode changes as follows:
TV mode os
{ CD changer or MD changer mode
Radio mode = (When the CD/MD changer is connected)
2
—
* Press and hold the FUNC button [7] for about
one second to turn off the power.
3) Slide the o-selector [1] to A (up) or VW
(down) to adjust the volume.
A. Increases the volume.
VW : Decreases the volume.
* The volume level indicated is in the display in
a range from 0 (minimum) to 33 (maximum).
4) Pressing the DISP button [10] alternates the
display contents as described below:
* If the display has been closed, the current time
will be shown in the Information Panel (21.
*If the display is open, the indication in the
Display [12] will change.
16 VRX8370R
Note:
Be
sure
to
read
this
chapter
referring
to
the
front
diagrams
of
chapter
‘2.
CONTROLS”
on
page
5
(unfold).
Note:
ein
the
CONFIGURATION
or
BALANCE
display,
the volume cannot be adjusted.
While
driving,
keep
the
volume
to
a
level
at
which
external
sounds
can
be
heard.
Opening
and
turning
the
display
1)
Press
the
OPEN
button
[3]
to
open
the
Display
[12].
Notes:
e Do not place any object on the open display.
e Do not drop any object on the movable part.
e Do not expose the display to shocks.
* If the display is left horizontally in the open posi-
tion for 10 seconds or longer, it is automatically
drawn in.
2) Turn the Display {12| upwards to a good view-
ing angle.
When the Display [12] is turned upwards, a
picture appears. Information Panel [2] display
disappears.
“Se —}-Turn the display Us
upwards by holding only ad
the front edge from the label.
OPEN button
Do not turn the display unless It is complete-
ly open.
When adjusting the angle of the display, be
careful not to let your fingers get caught by
the panel or instrument panel of the vehicle.
Do not hold the part of the display beyond
the label (see the illustration above).
3) To store the Display [12] in the source unit,
turn it to the horizontal position until a click is
heard.
*{f the Display [12] is turned to the horizontal
position during PS (Preset Scan) for a
TV/FM/AM (MW/LW) program or SCN (Scan)
for a CD/MD track, “SRCH?” will blink.
mp
pt
nat
a
ne
tessa
Patent
sed
San
MighthniAAie
NCE
HAI
EON
SN
shea
td
AT
eAARbbAG
Ne
6
oe
10
SN
ecb
yetny
ahs
ive
Brergatoredy
o
+