Clarion VRX8370R - Page 23

Volume setting of TA, emergency
(ALARM) and PTY
You can set the volume of TA, ALARM and PTY
to a desired level.
* The factory setting is “TA-VOL 11”.
1) Press and hold the TA button [6] for 2 sec-
-onds or longer to enter TA VOL ADJ mode.
lf the control is idle for 7 seconds after the TA
VOL ADJ mode has been entered, the dis-
play returns to radio mode display automati-
cally.
2) Select up or down to set the volume level
using the a-selector [1].
FRA1 eon—net71
STERE! CLASSICS
0
BE ofttinas
* The volume remains unchanged if the volume
before the TA, ALARM and PTY broadcasts
are received is higher than the previously set
volume.
if it is lower, the volume changes to the level
set in TA VOL ADJ mode.
3) Press the TA button [6] to complete volume
setting.
MS (Music Speech) function
While receiving speech programme with speech
data and this function is on, this enables you to
set the bass/treble to a constant level so that you
can listen to the speech programme clearly.
When speech is finished, the sound returns to
the original bass/treble adjustment.
* The factory setting is “OFF”.
1) Press the ADJ button [15].
2) Select up or down until “MS/ACT” is dis-
played using the o-selector [1].
3) Select right to turn “ON” or “OFF” using the
o-selector [1].
4) Press the ADJ button [15] again to return to
radio mode display.
RDS Operations
Note:
e When you receive speech data with the M/S func-
tion set to “ON” while a DSP/EQ such as
DPH9300, DPH7300 and EQH5100 etc. is con-
nected to this unit, the unit invalidates the
DSP/EQ adjustments.
* When receipt of speech data has finished, the
sound quality returns to the original bass/treble
adjustment level or the sound level set on the
DSP/Equalizer.
CT (Clock Time) function
The CT function enables you to display clock
time only when CT data is received.
Press the DISP button [13] to switch the display to
the CT indication.
* When CT data is not received, “CT~-:-—” is dis-
played.
Note:
e There are some countries and stations where
clock time data are not transmitted. In some
areas, the CT may not be displayed correctly.
VRX8370R 23