Clarion VRX8370R - Page 49

W@ Installing the Tuner Amplifier Unit
Before installing the tuner amplifier unit, position 1. Attach the mounting brackets on the left and
it considering safety and operability of the entire right side of the tuner amplifier unit using the
system. attached screws (M4 x 8). (Figure 9)
Sample installation (when the unit is installed 2. Position the tuner amplifier unit on the floor
under the front seats) carpet and drill holes through the carpet at
install the unit under the front seats using the the position where the holes of the bracket fit
included parts. If there are not enough space 3. Push the attached clips through the holes on
under the seats, consult the store where you the carpet into the bracket holes.
purchased the unit.
2—Mounting bracket
Floor carpet
4-Clip
4—Mounting screw (M4 x 8)
Figure 9
~6.
REMOVING
THE
SOURCE
UNIT
1.
When
the
rear
of
the
source
unit
has
been
the
spring
into
hole
&
of
the
hook
plate,
then
secured
with
the
method
shown
in
Figure
6
pull
the
source
unit
out
by
the
hook
plate.
unfasten
the
special
screw.
(insert
both
the
right
and
left
edges
of
the
2.
Remove
the
outer
escutcheon.
hook
plate.)
(Figure
10)
3.
Insert
the
hook
plate
between
the
spring
and
Note:
Keep
the
hook
plate.
You
cannot
remove
the source unit without disengaging the
the
universal
mounting
bracket,
fit
tab
©
of
hook
plate.
Instrument panel
Universal mounting bracket
2—Hook plate
Outer escutcheon
Figure 10
VRX8370R 49