Clarion VRX8370R - Page 50

~ 1. CAUTIONS ON WIRING
1. Be sure to turn the power off before wiring.
2. Be particularly careful where you route the wires. _
Keep them well aney from the engine, and exhaust pipe, etc.
Heat may damage the wires.
. {f the fuse should blow, check to see if the wiring is correct.
If itis, replace the fuse with a new one with the same amper-
age rating as the original.
. To replace the fuse, release the catch on the source unit side,
remove the old fuse and insert the new one. (Figure 11)
Note: There are various types of fuse holder. Do not let the
battery side and touch other metal parts.
Antenna
Tuner Amplifier Unit
Example 1: Main power supply (Yellow)
Fuse holder
Figure 11
After the connection, fix the lead by a clamp
or insulation tape for protection.
5. When connecting the ground lead, fasten the
ground lead (black) securely to a clean metal <)) < Sorew on car |
plate on the car. (Figure 12) >
If the set is insufficiently grounded, it may not ~ Fasten securely to a clean metal
og plate on the car.
operate or there may be noise.
Figure 12
50 VRX8370R