26
VX404
English
Symbol Identification
This manual uses symbols and icons to indicate
safety precautions and concerns during the
installation procedure. Be sure to carefully read
and understand each precaution prior to
beginning the installation.
WARNING
This symbol is intended to alert the user to the presence of important
operating instructions. Failure to heed the instructions may result in
severe injury or death.
WARNING
• Conrm the battery voltage of the vehicle to be installed. This unit is
designed only for vehicles with DC 12V power supply.
• Disconnect the negative terminal of the battery before connecting
wires, otherwise an electric shock, injury by short circuit may occur.
CAUTION
This symbol is intended to alert the user to the presence of important
operating instructions. Failure to heed the instructions can result in injury
or material damage.
Installation Precautions
WARNING
• When installing the unit to a vehicle with an airbag system, never install
it in a place where it may affect the operation of the airbag.
• Do not install this unit in the following locations:
A location interfering with the driver’s visual range or operation.
A location where the gear shift or brake pedal are hindered.
A location where passengers are at risk.
An unstable location, or where the system may fall.
CAUTION
• Do not install the system in the locations described below. This may
cause a re, accident or electrical shock:
A location exposed to rain or dust.
An unstable location, or where the system may fall.
• Do not install this unit in a place exposed to direct sunlight, heat or a
place where the vent holes or heat radiation holes are covered.
• When you install the antenna, mount it in a place where the elements of
the antenna do not protrude beyond the edge of the front, back, left and
right of the vehicle. If it comes in contact with pedestrians, it may
cause an accident.
VX404_quick start guide_EN_InDesign.indd 26 2014-4-4 13:58:44
To Next Page
Loading...
Need help?
General
