INSTALLATION AND WIRE
CONNECTION MANUAL
Contents
1. BEFORE STARTING............................................................................................................. 39
2. PACKAGE CONTENTS............................................................................................................ 39
3. GENERAL CAUTIONS............................................................................................................ 39
4. CAUTIONS ON INSTALLATION .................................................................................................... 40
5. INSTALLING THE MAIN UNIT .................................................................................................... 41
6. CAUTIONS ON WIRING .......................................................................................................... 43
7. WIRE CONNECTION ............................................................................................................. 44
1. BEFORE STARTING
1. This set is exclusively for use in cars with a
negative ground 12 V power supply.
2. Read these instructions carefully.
3. Be sure to disconnect the battery “- ” terminal
before starting. This is to prevent short circuits
during installation. (Figure 1)
2. PACKAGE CONTENTS
1. Main unit
2. Manuals
Owner’s manual & Installation manual
Warranty card
3. Power supply cord
4.
Bag for accessories (No. 1)
Flat head screw (M5 8)..................... 8 or 4
Sems hexagonal bolt (M5 8)............. 8 or 4
5. Remote control unit
6. Battery
(installed in remote control unit)
7. Finishers
3. GENERAL CAUTIONS
1. Do not open the case. There are no user-
serviceable parts inside. If you drop anything
into the unit during installation, consult your
dealer or an authorized Clarion service
center.
2. Use a soft, dry cloth to clean the case. Never
use a rough cloth, thinner, benzine, or alcohol,
etc. For tough dirt, apply a little cold or warm
water to a soft cloth and wipe off the dirt
gently.
Car battery
Figure 1
39
VX409/VZ409
English
Owner’s manual