8
Parts & Service: 020 8988 7400 / E-mail: Parts@clarkeinternational.com or Service@clarkeinternational.com
MOUNTING THE SANDER ON TO A WORKBENCH
Attach the machine to a workbench or stand before use.
1. Position the machine on the
workbench.
2. Mark the workbench through the
mounting holes in the sander
base.
3. Drill holes in the workbench at the
marks.
4. Use long bolts, spring washers and
nuts (not supplied), to secure the
machine to the workbench.
MOUNTING THE DUSTBAG TO THE SANDER
The sander is provided with a dust extraction facility. Please note however,
that this does not preclude the user from wearing a face mask to prevent the
inhalation of dust particles
1. Use the dustbag clip to secure the
dustbag to the dustbag bracket
as shown,
2. Fit the dustbag bracket over the
dust extraction port as indicated.
To Next Page
Loading...
Need help?
General
