Classeq Under Counter Range - User Manual
22
7. Maintenance and
Servicing
DANGER!
The warewasher MUST be disconnected from
its power source during cleaning, servicing or
when replacing parts.
DANGER!
Ensure the base of the warewasher is never
submerged or standing in water when
operating the warewasher.
Caution
DO NOT spray the exterior or interior of the
warewasher and the surrounding area
(panels, base) using a water hose, steam-jet
air ejector or high-pressure cleaner.
Caution
Ensure that the items placed on the open
door of the warewasher do not exceed 20kg
in weight.
7.1 Prior to Cleaning
Ensure the warewasher has first been drained down (►6.9).
Turn off the mains electrical supply before cleaning the
warewasher.
Warning!
DO NOT use cleaning agents that contain
CHLORINE, BLEACH or HYPOCHLORITE.
Warning!
Before cleaning the Wash Chamber, ensure
all sharp items, such as broken glass or other
items which could cause injury, are removed
carefully.
Caution
DO NOT use STEEL WOOL, WIRE BRUSHES or
any other abrasive materials.
7.2 Daily Cleaning
It is recommended that the warewasher is cleaned daily to
ensure good hygiene in the warewasher.
7.2.1 Interior cleaning
The interior of the warewasher should be cleaned after each
service when the warewasher is drained down.
As a minimum Classeq recommends the following are checked
and cleaned:
• Remove and clean the
top and bottom Rinse
and Wash Arms.
• Remove and clean the
primary and secondary
filters.
• Clean the interior of
the Wash Tank with a
sponge and/or brush
for all apertures and
outlets.
• Clean around the door
hinge.
• Use a small bottle
brush followed by a
trigger spray bottle
with a jet nozzle, clean
the ball in the anti-
syphon device
(pumped drain
warewashers only).
• If required apply food
grade grease to the
Door Ball Catch.
Ensure all arms and filters are refitted to the warewasher before
turning the warewasher on.
7.2.2 Exterior cleaning
Wipe the exterior of the warewasher with a damp (NOT WET)
sponge.
Once dry, clean using a STAINLESS-STEEL cleaning agent.
7.3 Limescale Build Up
For best results ensure your warewasher is operated with soft
water so that limescale does not build up.
If your warewasher is connected to an external Water Softener,
ensure this is routinely regenerated as per the manufacturer’s
instruction manual.
If your warewasher has an internal Water Softener fitted ensure
the salt level is maintained as per the instructions in this manual.
If your warewasher is operated with hard water, without the
relevant water treatment, the internal workings and water lines
To Next Page
Loading...
