Classeq Under Counter Range - User Manual
6
1.4 Cautions
Damage to the warewasher caused by lime scale or
poor water quality will NOT be covered by the
Manufacturer’s Warranty (►7.3).
In hard water areas (>3°dH), DO NOT run the
warewasher without the use of either an internal or
external water softener as this could result in damage
to the warewasher. Failure to observe this warning will
invalidate the warranty.
Warewashers with WS in the model type are fitted with
an internal water softener.
DO NOT run the warewasher without salt in the Salt
Reservoir as this will allow limescale to build up.
Limescale deposits in the warewasher will invalidate
the warranty (►4.5.2).
Only use granulated salt (max. grain size 7 mm). Salt
tablets are not suitable (►7.4.1).
DO NOT add any chemicals, such as detergent or rinse
aid to the Salt Reservoir. These will cause damage to
the warewasher (►7.4.1).
Only use commercial grade detergents and rinse aids
in your warewasher (►4.7).
If the Salt Reservoir Cap is not properly secured, water
and/or chemicals can leak in or out of the unit causing
damage to the warewasher (►7.4.1).
Always remove excess food / debris from any dishes /
glasses to be washed. DO NOT use your warewasher
as a waste disposal unit (►6.8).
It is very important that the warewasher is drained
down at the end of each working day (►6.9).
DO NOT use STEEL WOOL, WIRE BRUSHES or any
other abrasive materials.
De-scale chemical must not remain in the warewasher
for more than 2 hours (►7.5).
Items placed on the open door of the warewasher
must not exceed 20kg (►7).
DO NOT spray the exterior or interior of the
warewasher and the surrounding area (panels, base)
using a water jet, steam cleaner or high-pressure
cleaner.
The function of this warewasher is the washing of
dishes, plates, glassware, cutlery, and similar articles
only. No other activity is permitted with this
warewasher.
Authorised spare parts only must be used in the event
of a breakdown.
To Next Page
Loading...
