Classeq C500 - 1.2 Danger Warnings; 1.3 Warnings

90001697 Classeq Under Counter Range - User Manual
5
EN
1. Safety
1.1 Symbols Used in this Manual.
The following symbols are used in this Manual:
DANGER!
Warning against potential serious or fatal
injuries to persons if the described
precautionary measures are not taken.
Warning!
Warning against potential minor injuries to
persons or potential material damage if the
described precautionary measures are not
taken.
Caution
Warning against defects in or destruction of
the product if the described precautionary
measures are not taken.
Recycling instructions.
►
This symbol refers to a chapter with more
detailed information
For safety reasons the warewasher MUST be
bonded to adjacent metalwork or earthed
so that it is at the same potential (i.e.
voltage).
For safety reasons, two persons are
required for the task.
1.2 Danger Warnings
For safety reasons your warewasher MUST
be bonded to adjacent metalwork or earthed
so that it is the same potential (i.e., voltage)
(►4.4).
A means for disconnection that has all poles
separation of more than 3mm must be incorporated
in the fixed wiring in accordance with wiring rules
(►4.3).
If a mains supply cable is damaged, it must be
replaced by a cable supplied by Classeq, its service
agents or similar qualified persons, to avoid hazards.
All mains electrical work must be carried out in
accordance with local and national regulations, and by
a qualified electrician (►4.4.1).
Ensure the base of the warewasher is never
submerged or standing in water when operating the
warewasher (►7).
1.3 Warnings
The warewasher should only be operated at or within
the voltage specified on the rating plate (►2.3).
If Classeq warewashers are used outside the
designation for the appliance, you invalidate your
warranty and make the appliance unsafe.
Maximum inlet water pressure is 1 MPA and minimum
inlet water pressure is 200 kPA.
Use only the hose supplied with your warewasher to
connect it to the water supply. Old existing, defective,
or damaged water supply hoses MUST NOT be used
(►4.5.3).
The installer and user are responsible for ensuring the
installation and operation of this warewasher are in
accordance with this Manual and local and national
regulations (►4).
DO NOT use electrical extension lead(s) to supply
power to your warewasher (►4.4.1).
Children should be supervised to ensure that they do
not play with or operate the warewasher (►6).
Be aware that wares may be hot when removed from
the warewasher (►6.8).
Before cleaning the Wash Chamber, ensure all sharp
items, such as broken glass or other items which could
cause injury, are removed carefully.
DO NOT use cleaning agents that contain CHLORINE,
BLEACH or HYPOCHLORITE.
Wear the correct Personal Protective Equipment, e.g.,
gloves and goggles, when handling chemicals and
observe all safety notes and dosing recommendations
printed on the packaging. (►4.7) (►7.5) (►10.1).
If the warewasher is being drained immediately after
use, water draining from the ‘Boiler drainage hose’
may be hotter than 95°C (►10.4).
For models fitted with an internal drain pump, the
wastewater outlet MUST not exceed the maximum
drain height.