Classeq C500 - Warewasher overflowing.; Poor wash results.

Classeq Under Counter Range - User Manual
30
Warewasher runs
through a full
cycle but does
not rinse.
If your warewasher
runs through a full
cycle, but does not
rinse, you will need
to request a service
callout to identify
the root cause of
the problem.
Warewasher
overflowing.
E16
Wrong Drain Plug
fitted.
Check that the
Drain Plug is the
right one for the
warewasher (►4.6).
Primary /
Secondary Filters
blocked.
Check the Primary /
Secondary Filters -
if blocked remove
and clean
thoroughly.
There is a problem
with the drains
system.
Check that the
warewasher waste
hose is not kinked
or blocked.
Check that the site
waste is not
blocked.
If the warewasher
continues to
overflow isolate the
warewasher and
request a service
callout.
Poor wash
results.
Warewasher not
being supplied
with soft water.
Check the
operation of the
Water Softener
(external or
internal) if fitted.
If external,
regenerate the
Water Softener.
If internal, check /
refill the Salt
Reservoir.
There is a problem
with the wash and
rinse aid
chemicals system.
Check the level of
chemicals within
the detergent and
rinse aid bottles.
Ensure the bottle
weights and tubes
are correctly
positioned.
Check the chemical
dosing rates are
correctly set (►).
Warewasher not
properly cleaned.
Ensure that the
warewasher is
regularly cleaned
(►7.2).
Check for presence
of beige or black
film deposits
around the door
and door hinges of
the warewasher
indicating a build-
up of growing yeast
cells.
Check glasses and
renovate if
required.
Warewasher does
not drain.
Wrong Drain Plug
fitted.
Check that the
Drain Plug is the
right one for the
warewasher (►4.6).
Primary /
Secondary Filters
blocked.
Check the Primary /
Secondary Filters -
if blocked remove
and clean
thoroughly.
There is a problem
with the drains
system.
Check that the
warewasher waste
hose is not kinked
or blocked.
Check that the site
waste is not
blocked.
Correct drain
procedure is being
used for the
warewasher type
(►6.9).
Ball in anti-syphon
device dirty /
blocked (pumped
drain
warewashers
only).
Remove the anti-
syphon device
cover inside the
warewasher, gently
clean the ball by
inserting and
agitating a small
bottle brush, flush
using a trigger
spray bottle with a
jet nozzle.
Warewasher will
not turn off when
the On/Off button
is pressed.
There is a problem
with the
warewasher’s
control / electrical
system.
Isolate the
electrical supply to
the warewasher,
turn off the water
supply, and request
a service callout.