3. Setting up: Connections ddrum4 SE V1.5x
Page 10
3. S
3. S3. S
3. SE
EE
ET
TT
TT
TT
TI
II
IN
NN
NG
GG
G
U
UU
UP
PP
P
C
CC
C
O
OO
ON
NN
NN
NN
NE
EE
EC
CC
CT
TT
TI
II
IO
OO
ON
NN
NS
SS
S
1. Make all the connections before turning on the ddrum4 SE. Turn on the ddrum4 SE module with
the M
ASTER
L
EVEL
knob at 0.
2. Connect the pads to the ddrum4 SE module according to the illustration below.
3. Connect the main outputs, marked A1 and A2 on the ddrum4 SE rear panel, to a suitable sound sys-
tem. If you’d rather use a pair of headphones, a headphones jack has been provided. The M
ASTER
L
EVEL
knob lets you adjust the output volume of the H
EADPHONES
output and of the line level out-
puts A1 and A2. The line level outputs B3 to B6 are not affected by the M
ASTER
L
EVEL
knob.
4. Connect the mains cable and power-up your system in the following order:
ddrum4 SE - mixer - amplifier.
The very first thing that will appear in the ddrum4 SE D
ISPLAY
is the software version number. After a
brief moment, ‘PAL’ will appear in the D
ISPLAY
. This indicates that the ddrum4 SE is in the Palette
mode.
S
SS
S
E
EE
ET
TT
TT
TT
TI
II
IN
NN
NG
GG
G
U
UU
UP
PP
P
T
TT
TH
HH
HE
EE
E
I
II
IN
NN
NP
PP
PU
UU
UT
TT
T
C
CC
CH
HH
HA
AA
AN
NN
NN
NN
NE
EE
EL
LL
LS
SS
S
The ddrum4 SE module can be used with a variety of pads. After you have connected the pads of your
choice, please proceed with the following procedure. When shipped from the factory the ddrum4 SE is
set to kick (bAS) trigger on the kick channel, rim (rin) trigger on the rim channel, pad (PAd) trigger on
the tom and percussion channels, cymbal (CYb) trigger on the cymbal channel and hi-hat (HHt) on the
hi-hat channel. If your ddrum4 SE was shipped with ddrum Cast Precision Pads, you do not have to
change the settings. If your ddrum4 SE system was shipped with the Cast Precision Mesh Head Pads the
snare, toms and percussion channels should be set to mesh head 1 (nh1).
Rim
Kick Snare
Tom High
Tom Mid
Tom Low Perc
Cymbal Cymbal Hi-hat
To Next Page
Loading...
