Cleanware HT-E - WASHING A RACK OF WARE; ALARMS

07610-004-64-85-A
10
INSTRUCTIONS
OPERATION
Open the door completely, slide a rack into the machine, and close the door. Choose
the wash cycle with the CYCLE button. Press the START button and the cycle light
will illuminate. When the cycle is complete, the cycle light will turn o󰀨. Open the door
and remove the rack.
Based on use, the strainers might become clogged with soil and debris as the
workday progresses. Operators should regularly inspect the strainers to ensure they
have not become clogged. If clogged, the washing capability of the machine will
be reduced. Instruct operators to clean out the strainers at regular intervals or as
required by workload.
Time-out Tank Filling: If the level in the wash tank has not been reached within ve
minutes and ten seconds, the lling solenoid valve is disconnected and the cycle light
starts blinking with a frequency of 0.5 seconds. To restart lling and to disconnect the
alarm, push the START button or turn the machine o󰀨 and on by pressing the POWER
button twice.
Determine the reason for machine not lling and x (see Troubleshooting section)
before switching the machine on.
Booster Heating (with Thermo Stop): If the minimum booster temperature has not
been reached within eight minutes, the machine will pause and a rinsing phase will
follow. The cycle light starts blinking with a frequency of 0.3 seconds and keeps blinking
after the cycle ends. To disconnect the alarm, turn the machine o󰀨 and on by pressing
the POWER button twice.
Determine the reason for temperature not being reached and x (see Troubleshooting
section) before switching the machine on.
Open Door: If door is opened at any time during the wash cycle, the cycle stops, all
machine functions are cut o󰀨 (except heating elements), and the cycle light starts
blinking with a frequency of 0.5 seconds. If door is closed, the cycle restarts from the
stopping point and the cycle light stays on.
If alarm activates with the door closed, ensure the door switch is in correct position and
works properly.
WASHING A RACK
OF WARE
OPERATIONAL
INSPECTION
ALARMS
set
set
POWER BUTTON
CYCLE LIGHT
START BUTTON
set
set
CYCLE BUTTON
START BUTTON
CYCLE LIGHT