Cleanware HT-E - DRAINING; SHUTDOWN & CLEANING

11
07610-004-64-85-A
DRAINING
1. With machine on, open the door.
2. Remove the standpipe.
3. Hold the START button for about ve seconds.
4. When the cycle starts, close the door.
5. Total tank draining takes about three minutes.
6. After draining is complete, turn machine o󰀨 by pushing the POWER button.
Leave machine o󰀨 for at least ten seconds (this resets machine to normal
function).
1. Follow the Draining section.
2. Once machine is drained, turn power o󰀨 and remove all debris from the strainers.
3. Remove rinse and wash arms.
4. Verify the rinse arms are not clogged. If so, remove end-caps with a 12 mm
wrench, clean nozzles with a brush, and flush with fresh water. Inspect end-cap
o-rings and replace if damaged. Replace end-caps and tighten.
INSTRUCTIONS
OPERATION
SHUTDOWN &
CLEANING
set
set
set
set
WARNING! Water
will be hot!
!
WARNING
Removing End-cap O-RingNozzles