Cleanware HT-E - DELIMING

13
07610-004-64-85-A
DELIMING
To perform a deliming operation, follow the steps below. The tank capacities of the
machine can be found in the Specications section of this manual.
1. Follow the Filling the Wash Tank section.
2. Once rinse and wash lights have gone out, press the DELIME button to turn o󰀨
the chemical feeder pumps.
3. Add deliming solution to wash tank per chemical supplier's instructions.
4. Close the door.
5. Use the CYCLE button to select the heavy cycle.
6. Push the START button.
7. The cycle light will illuminate. When cycle is complete, the cycle light will go out.
8. Wait until cycle is complete and inspect the inside of the machine. If the
machine is not delimed, run again.
9. If the machine is delimed, follow the Draining section.
10. After draining is complete, turn machine o󰀨 by pushing the POWER button.
Leave machine o󰀨 for at least ten seconds (this resets machine to normal
function).
11. Press the DELIME button to turn the chemical feeder pumps back on.
12. Press the POWER button.
13. Run two cycles with no ware to remove residual deliming solution.
If this machine is equipped
with the SPS scale
prevention and corrosion
control device and lime is
becoming a frequent
problem, the cartridge
needs to be replaced.
To order a replacement
cartridge, call the
manufacturer.
NOTICE
INSTRUCTIONS
OPERATION
set
set
set
set
set
set
set
set
!
CAUTION
set
set
set
set
CAUTION! This equipment
is not recommended for
use with deionized water
or other aggressive uids.
Use of deionized water or
other aggressive uids
will result in corrosion
and failure of materials/
components and will
void the manufacturer’s
warranty.