Clear-Com Communication Systems
Encore System Installation Instruction Manual
1-14
A Main Station, such as the MS-232 or MS-702can be configured to
provide program audio on a channel but allow this audio to be
interrupted whenever the Talk button for that channel is pressed. If a
Remote Station, such as the RM-220 or RM-702 is used along with the
Main Station in this configuration, it can be important to have the
program audio interrupted by the operator of either station. To do this,
the Main or Remote Stations must be set up as follows:
• Enable the Momentary Talk option switch or jumper on the
appropriate channel of the Main and Remote Stations. Refer
to the User Manual for to locate this switch or jumper. This
will cause the Talk button to have a momentary only action
and not latch.
• Enable the Call on Talk option switch or jumper on the
appropriate channel of the Main and Remote Stations. Again,
refer to the User Manual for these stations to locate this
switch or jumper. This will cause the Call signal to be
activated whenever the Talk button is held down.
• Feed the program audio into the Program Audio connector on
the Remote Station.
With this setup, any Call signal on this intercom channel, including Call
signals from beltpacks, will cause the program audio to be interrupted.
To Next Page
Loading...
Need help?
General
