Clevo N650DU Series - Removing the Optical Device

Disassembly
2 - 10 Removing the Optical Device
2.Disassembly
Removing the Optical Device
Figure 6
ODD Removal
a. Remove the screw.
b. Push the optical device
out of the computer.
c. Pry the bezel off the opti-
cal device.
d. Separate the bezel and
optical device
e. Install the front bezel.
1. Turn off the computer, turn it over, and remove the battery (page 2 - 5) and the component bay cover (page 2 - 6).
2. Remove the screw at point , and use a screwdriver to carefully push out the optical device at point .
3. Carefully pry the bezel off the optical device at point (Figure 6c
).
4. Separate the bezel and the optical device as shown (Figure 6d).
5. Reverse the process to attach the front bezel with the new optical device at point (Figure 6e).
6. Insert the new device and carefully slide it into the computer (the device only fits one way. DO NOT FORCE IT; The
screw holes should line up). Replace the bottom cover and tighten the screws.
7. Restart the computer to allow it to automatically detect the new device.
1
3
2
5
4
5
5
6
b.
a.
2
3
1
e.c. d.
4
6
5 5

3. Optical Device
5. Bezel Cover
•1 Screws