Clevo N650DU Series - Removing the 3 G Module

Disassembly
2 - 18
2.Disassembly
Removing the 3G Module
1. Turn off the computer, turn it over to remove the battery (page 2 - 5) and bottom cover (page 2 - 6).
2. The 3G module will be visible at point on the mainboard (Figure 14a).
3. Carefully disconnect the cables & , and then remove the screw (Figure 14b)
4. The 3G module (Figure 14c) will pop-up, and you can remove it from the computer.
5. Reverse the process to install a new module (do not forget to replace all the screws and bottom cover).
1
2
3
4
5
b.
c.
a.
2
3
5
1
5
4

5.3G Module
•1 Screw
Figure 14
3G Module Removal
a. Locate the 3G.
b. Disconnect the cable
and remove the screw.
c. The 3G module will pop
up and lift it out of the
computer.
Note: Make sure you
reconnect the antenna
cable to the “1 + 2”
socket (Figure 14b).