Clevo N650DU Series - Removing the WLAN Module

Disassembly
Removing the WLAN Module 2 - 19
2.Disassembly
Removing the WLAN Module
1. Turn off the computer, turn it over to remove the battery (page 2 - 5) and bottom cover (page 2 - 6).
2. The WLAN module will be visible at point on the mainboard (Figure 14a).
3. Carefully disconnect the cables & , and then remove the screw (Figure 14b)
4. The WLAN module (Figure 14c) will pop-up, and you can remove it from the computer.
5. Reverse the process to install a new module (do not forget to replace all the screws and bottom cover).
1
2
3
4
5
b.
c.
a.
2
3
1
5
4

5.3G Module
•1 Screw
Figure 15
WLAN Module
Removal
a. Locate the module.
b. Disconnect the cable
and remove the screw.
c. The module will pop up
and lift it out of the com-
puter.
Note: Make sure you
reconnect the antenna
cable to the “1 + 2”
socket (Figure 14b).