Modules & Options
3.75G/HSPA Module 7 - 35
7
3. Click OK alongside any of the options to configure the settings.
4. The Network can be configured for an Automatic (usually from the USIM card) or
Manual connection.
5. The Network Mode can be configured for any appropriate mode required.
6. You can also change your settings for the Pin #, and input your phone number.
7. Exiting the program DOES NOT turn off the 3.75G/HSPA module, and you will
need to press the Fn +
key combination to turn off the module (pay careful
attention to this aboard aircraft - see “Wireless Device Operation Aboard
Aircraft” on page 7 - 27).
8. If the module is on and the computer enters a power-saving state, then the power
status of the module on resuming from the power-saving state will be as below:
• If the 3.75G/HSPA module is on and the computer is Shut Down or Restarted;
the module will be off when the computer starts up.
• If the 3.75G/HSPA module is on and the computer enters Sleep or Hibernate;
the module will be off when the computer resumes from sleep.
Figure 7 - 30
Settings - Network/
Network Mode
To Next Page
Loading...
